Dentitions of the sympatric herbivorous dinosaurs Hungarosaurus (Ankylosauria, Nodosauridae) and Mochlodon (Ornithopoda, Rhabdodontidae) (Santonian, Hungary) were analysed to investigate their dietary ecology, using several complementary methods—orientation patch count, tooth replacement rate, macrowear, tooth wear rate, traditional microwear, and dental microwear texture analysis (DMTA). Tooth formation time is similar in Hungarosaurus and Mochlodon, and traditional and DMTA microwear features suggest low-browsing habits for both taxa, consistent with their inferred stances and body sizes. However, Mochlodon possesses a novel adaptation for increasing dental durability: the dentine on the working side of the crown is double the thickness of that on the balancing side. Moreover, crown morphology, enamel thickness, macrowear orientation, and wear rate differ greatly between the two taxa. Consequently, these sympatric herbivores probably exploited plants of different toughness, implying dietary selectivity and niche partitioning. Hungarosaurus is inferred to have eaten softer vegetation, whereas Mochlodon likely fed on tougher material. Compared to the much heavier, quadrupedal Hungarosaurus, the bipedal Mochlodon wore down more than twice as much of its crown volume during the functional life of the tooth. This heavy tooth wear might correlate with more intensive food processing and, in turn, could reflect differences in the metabolic requirements of these animals.

The photocatalytic activity of TiO2 can be increased by incorporating it into a composite with an electron-trapping co-catalyst. MXene can perform this task as an electron-conducting material. In addition to trapping electrons, it also affects the defects in TiO2 near the interface. To screen for the best photocatalytic performance, three types of composites were prepared: by physical mixing, chemical deposition, and ALD. During characterization, the structural, optical, and photoelectrochemical properties were determined. Photocatalytic activity was examined in suspension (phenol conversion) and on a layer (gas phase ethanol conversion). It was found that the composite containing the lowest proportion of cocatalyst (1 wt.%) had the highest photocatalytic activity. According to the results of photocatalytic activity measured in suspension, the physical mixtures were proven to be more effective than neat TiO2, with the composites converting approximately the total amount of phenol in ~40 min, while TiO2 required ~80–90 min to do so under the same conditions. Thus, the electron-trapping role of MXene is clearly demonstrated in suspension applications, which is also confirmed by other characterization methods (photoluminescence, photocurrent density). TiO2 performed best during ethanol conversion, as it has the highest ethanol adsorption capacity (33.41%). During ethanol conversion tests, the MXene electron-trapping property was most effectively demonstrated in composites formed using the ALD method.

The photocatalytic activity of semiconductors can be tuned by changing their morphological or structural properties. However, a simpler and direct method is the introduction of a cocatalyst, for example V2O5 or V2O5/V4O9. In the present work, this was the cocatalyst added to SrTiO3. The deposition method was directed in such a way that the cocatalyst did not cover the surface of the SrTiO3 completely. This way, the photocatalytic process (phenol conversion) takes place at the surface of the main catalyst, while the lifetime of the generated charge carriers is increased through electron trapping via the presence of vanadium oxides. The V2O5/V4O9 cocatalyst influences the recombination processes of excited electrons in SrTiO3 by modifying the near-surface defects of SrTiO3, and it can efficiently capture electrons due to the formed heterojunction. The V4O9 content enables efficient electron transfer, as its structure can accommodate V⁴⁺ in addition to V⁵⁺. Therefore, a mixed-phase semiconductor is more suitable as a cocatalyst than a single-phase semiconductor. In this work, the photocatalytic activity of SrTiO3 was investigated in the presence of V2O5 (0–20 wt.%). It was found that all the samples that contained the cocatalyst showed higher photocatalytic activity than the unmodified SrTiO3. The sample containing 10 wt.% of cocatalyst performed ~5.4 times better than pristine SrTiO3 (35.87 µmolphenol/gcatalyst, vs. 7.74 µmolphenol/gcatalyst). This sample also contains a relatively high amount of V4O9 compared to the other samples, in addition to V2O5, which may be the main reason for the enhanced photocatalytic performance.