Methods of increasing the bearing capacity of corrugated metal structures of transport constructions using transversal stiffening ribs in the form of additional corrugation and stiffeners are given. Based on the theory of elasticity, a mathematical model for estimating the stress-strain state of transport constructions made of corrugated metal structures reinforced with stiffening ribs in the form of double corrugation was developed. The method of determining equivalent forces during rolling stock passage is offered. It has been established that double corrugation increases the bearing capacity of corrugated metal structures. Therefore, additional corrugation of corrugated metal structures reduces stresses by up to 20% and deflections by 50%. The obtained results show that the increase in rolling stock speed does not lead to a significant increase in stresses and strains in CMS when the railway track corresponds to the design state.

The relatively high maintenance costs of the ballast track are related to the short lifecycle of the ballast layer. The current vertical ballast tamping technology (e.g., Plasser & Theurer, Matisa, etc.) causes high ballast destruction and is neither applicable for unconventional sleepers’ designs nor slab tracks. The side tamping method presents an alternative, ballast saving, and sleeper form independent ballast tamping technology. This paper compares the ballast layer compaction and its resistance to permanent settlements accumulation after the vertical and the side tamping methodologies. Scaled models of ballast layer and tamping units and scaled simulation with discrete element method (DEM) were applied for the comparison. In the laboratory tests, the ballast compaction along the sleeper was estimated using the measurements of elastic wave propagation. The settlements resistance for both tamping methods was estimated under the vibration loading. The tests’ results show 5–7% higher compactness of the ballast layer under the sleeper ends for the side tamping method. The settlement intensity of the ballast layer after the vertical tamping is higher than for the side tamping method. In discrete element modeling, the performed laboratory tests were simulated. The compactness of the ballast bed, as well as the residual stresses, were determined in MATLAB. The side tamping technology provided five times higher residual stresses in the ballast layer below the sleeper than in the case of vertical tamping, which can be explained by the more stable and dense layer resulting from the side tamping ensures higher interlocking between the grains. The simulation of the wave propagation shows an influence of the residual stresses on the wave propagation velocities. The simulated wave propagation velocity was more than two times higher for the side tamping than for the vertical one.

The present paper deals with the experimental investigation of interlocking effect of crushed stone ballast material, assessing it as the relationship with the residual and dynamic stresses under the ballast layer during laboratory dynamic tests with the consideration of different boundary conditions. The laboratory experiments were executed with a scaled model of ballast under the sleeper. The measured pressure at the bottom surface of the ballast has two parts: dynamic and residual. The dynamic part depends on the external loading; the residual part remains after unloading. The measured residual stress was observed up to 3 times higher than the stress due to cyclic external loading. The relationship of the residual stress and interlocking effect to ballast particles angularity is analyzed. A simple interpretation of the distribution of residual stress is proposed, that depends on the measured cyclic stress and the elasticity of bounding walls. The study of interlocking effect of ballast could be potentially useful for many practical problems of railway track design as well as for the track maintenance issues.